|
What are needed design for Pyrolysis
process?
Design and fabrication of experimental setup
Introduction
The design and fabrication of the batch type fixed bed pyrolysis was
major part of this project work and maximum time had been spent to redesign,
construct, and assemble the experimental setup. The main parts of the
system are fixed bed reactor, heater, condenser and liquid collector.
The pyrolysis system is designed based on the following consideration:
1. Reliable heat supply for required heating of the system.
2. Adequate gas flow rate to dispose of the vapor mixture.
3. A proper mass flow rate of vapor and water for proper condensation.
4. A size of the system such that sufficient amount of pyrolysis liquid
can be produced.
5. Rapid heat transfers into the reactor from internal for less heat
loss.
3.2 Description of work
3.2.1 Introduction
Various operations were performed in different shops and laboratory
of an University . Some operation were Performed at outdoors shops.
In machine shops maximum operations were performed. The welding and
brazing operations are done it Sheet Metal and welding shops. As material
used was stainless steel; it was difficult to carry out the operations.
|
